Fullscreen Teleprompter

For mobile creators

Teleprompter for phone and tablet

A teleprompter for phone turns the screen you already carry into a reading surface. You open the prompter in the mobile browser, paste the script and let the words scroll at the pace you speak, while a second device films you. That setup works for vertical video, for a quick update recorded at a desk and for anyone who has no separate monitor. This guide explains the two device rig, the touch controls and the honest limits of reading a small screen at arm's length. Everything runs in the mobile browser, so there is no app to install and the script never leaves the device you typed it on.

Use the phone as the prompter screen

The prompter is a web page, so the phone needs nothing but a browser. Open the page, add it to the home screen and it behaves like an app that opens without a connection bar. The script is written in the editor, saved in the browser of that device and read back when you come to it later.

  • Nothing is installed and there is no account. The script stays in the local storage of the phone.
  • The page keeps working with no connection once it has loaded, so a basement or a lift is not a problem.
  • The same settings are shared between the phone and the computer, if you open the tool on both.
  • Fonts, speed and margins are saved with the script, so a phone set up for filming is ready in one tap.

The prompter reads the script and scrolls it. It does not record anything and it does not follow your voice, so the filming is still done by your camera app.

The two device setup that works

One device cannot be the prompter and the camera at the same time, unless you film with a second camera. The working arrangement is simple: the phone with the prompter sits on a stand in front of you, and a second device films you while showing the prompter page, or the other way round.

  1. Put the recording device first
    Set up the camera, its height and its angle, and start recording. The camera should be at eye level, not looking up at you from a desk.
  2. Place the prompter under the lens
    Put the phone with the script as close to the camera as you can, directly below it. If the phone sits to the side, your eyes will drift sideways and the recording will show it.
  3. Start the prompter with a countdown
    Open the script, set the speed and press start. The countdown of 3 seconds gives you time to look up at the camera and breathe before the text starts moving.
  4. Check the first ten seconds
    Stop the recording, watch the start of the clip and look at your eyes, not your wording. If the eyes move, move the phone closer to the camera or narrow the column of text.

Portrait mode for vertical video

Vertical video is shot with the device upright, in a 9:16 frame, and the prompter has to be read the same way. Turn the phone to portrait before you paste the script, because the tool reads the text you give it and does not rewrap a sideways paste into a narrow column.

  • In portrait, the text column has to be narrow, so raise the font size rather than the line length.
  • The font size runs from 24 to 120 pixels. On a phone, 40 to 60 pixels reads well at arm's length.
  • The margins can go from 2% to 35% on each side. On a phone, 10% is enough to keep the column clear of the edges.
  • Rotate the phone back to landscape for a long script read aloud to camera, and back again to record.

Touch controls instead of keyboard shortcuts

There is no keyboard on a phone, so everything is done with the buttons along the bottom of the screen. They hide themselves after a couple of seconds of no movement, and any tap on the text brings them back.

  • The play button starts and pauses the scroll.
  • The speed slider runs from 60 to 300 words per minute, in steps of 5.
  • The two magnifier buttons change the font size by 2 pixels at a time.
  • The two flip buttons turn on the horizontal and the vertical mirror.
  • The target button cycles the reading guide between band, arrows, line and none.
  • Dragging the text moves the scroll position by hand, which is useful after a pause.

A Bluetooth presentation remote works as well as the keyboard, with the play button and the direction pad mapped to play, speed and jumping between paragraphs.

Keep the screen on, watch the battery and the heat

The prompter does not keep the screen awake on its own, and it should not pretend to. On a phone, the practical answer is to set the screen timeout to the longest time your system offers before you start, and to have the phone plugged in if the recording is long.

  • A phone at full brightness in a dark room runs down the battery in a couple of hours of continuous scrolling.
  • The black OLED screen is the easiest on the battery and the least tiring on the eyes at night.
  • The screen heats up if it stays on at full brightness, and a hot phone slows down and dims the display.
  • Lower the brightness and raise the font size instead of pushing the brightness up to read a small text.

The honest limits of a teleprompter for phone

A phone screen is small. Held at arm's length, around 40 centimetres from your eyes, the reading area is a fraction of what a monitor gives you, and holding a phone in the air for a three minute take is harder than it looks. The text also stops scrolling when you look away to check the camera.

  • Keep the script short on a phone. Ten or fifteen second takes read better than three minute takes.
  • Use a stand or a stack of books. A phone held in the hand drifts out of frame and moves the text with it.
  • Raise the font size to 40 pixels or more, and drop the speed below 140 words per minute if the text feels far away.
  • For a long script, a tablet or a laptop is the better screen. The phone is best as the second device, reading the script while a laptop films.

References and tools

If you are also learning the filming side, these are the official guides for recording on a phone and for vertical formats.

Frequently asked questions

Is there a teleprompter app for my phone?
You do not need an app. This teleprompter is a web page, so it opens in the browser of your phone, iPhone or Android, and you can add it to the home screen. There is nothing to install, no account to create and the script stays in the local storage of the phone.
How do I record while the script is on my phone?
Use two devices. One holds the prompter with the script, standing under the camera, and the second one records you. Put the prompter as close to the lens as possible, start the countdown of 3 seconds and check the first ten seconds of the take before you go on.
Can I use the same phone for the script and the recording?
Not for a normal talking head take. The camera and the script cannot both be in the right place on one screen, and the phone would have to film itself. If you only have one device, film in short takes with the script above the camera and check each clip.
Does the phone prompter work without a connection?
Yes. Once the page has loaded, the prompter keeps working with no connection, because the text and the settings are stored on the device itself. That makes it usable in places with no signal, such as a basement studio or a field shoot.
Why does the text feel small on my phone?
Because the screen is small and you are reading it at arm's length, about 40 centimetres from your eyes. Raise the font size with the magnifier buttons until the text is comfortable, and if it still feels far away, move the phone closer to the camera.

Open the teleprompter on your phone

Open the teleprompter in the browser of your phone, paste the script and press start. The text scrolls at your pace, you control it with the buttons on the screen and the script never leaves the device.

Open the teleprompter

Support this project

If you'd like to support the project, take a look at these beautiful illustrated products. I'm also a fantasy illustrator, and you can support me by buying prints. I'm sure you'll find something special for you, for a friend or for family.